Materials and tools needed:

Findings

Synthetic Moonstone Beads, Frosted, Round, Clear, 6mm

Round Leather Cord, Necklaces Making, Black

Copper Jewelry Wire, Chocolate, 20 Gauge, 0.8mm

Copper Jewelry Wire, Light Gold, 26 Gauge, 0.4mm

Tools

Flat nose pliers

Side-cutting pliers

Round nose pliers

Wire Wrapping Tool

Instructions on how to make the necklace:

Step 1:

1st, Cut four pieces of 0.4mm copper wire with the same length and make the length as long as possible.

2nd, Combine the four pieces of copper wires together, then wind a 0.8mm copper wire in the middle position. (as shown in the picture)

3rd, String a moonstone on the 0.8mm copper wire, and then wind the 0.4mm copper wire as shown in the picture.

4th, Continue to make this until there are three moonstones.]

Step 2:

1st, Wrap a shorter 0.8mm copper wire transversely on the 0.8mm copper wire.

2nd, String moonstones and winding on the horizontal 0.8mm copper wire as shown in the picture. 4 moonstones are needed on the horizontal copper wire.

Step 3:

1st, Wind the 0.4mm copper wire on the horizontal 0.8mm copper wire a few times and then continue the beading and winding in the longitudinal direction. (as shown in the picture)

2nd, At the end, it is necessary to wind the 0.4mm copper wire one by one on the 0.8mm copper wire several times. (as shown in the picture)

3rd, Cut off the excess copper wire and bend all four ends of the 0.8mm copper wire into a loop. (as shown in the picture)

Step 4:

Finally, use 0.8mm copper wire to make a 4-layer ring, and connect the cross pendant to the leather necklace.

If you like this kind of cross pendant, you can also use other beads to make it like this. It can be matched with different chains or necklaces. This is a good opportunity, Nbeads can provide you with a wealth of handmade materials.