Materials and tools needed:

Findings

Dyed Glass Pearl Round Beads Strands, White, 6mm/8mm/10mm/12mm

Glass Beads Strands, Faceted, Rondelle, Clear, 6x5mm

Transparent Glass Beads Strands, Faceted Cone, White, 12x6x6mm

Craft Copper Wire, Golden, 0.3mm

Aluminum Craft Wire, Gold, 15 Gauge, 1.5mm

Tools

Needle Nose Pliers

Round Nose Pliers

Side Cutting Pliers

Instructions on how to make the crown:

Step 1:

1st, Cut a piece of 1.5mm gold aluminum wire and twist it into a hair band shape. (as shown in the picture)

2nd, Cut a long piece of 0.3mm gold copper wire, wrap a few loops on one end of the hair band. (as shown in the picture)

3rd, Thread a 6mm crystal bead with the copper wire, wrap two loops to fix on the hair band. (as shown in the picture)

4th, Thread a 6mm pearl bead with the copper wire, wrap two loops to fix on the hair band. (as shown in the picture)

5th, Repeat this until the entire hair band is covered with crystals and pearls.

6th, Cut another piece of 0.3mm gold copper wire, slide two cone glass beads, a 6mm pearl bead, a 12mm pearl bead and a 6mm crystal bead onto the wire. Then thread the copper wire back through the 6mm and 12mm pearl beads, and slide another two cone glass beads onto the wire.

Step 2:

1st, Fix the bead pattern in the middle of the hair band, and then fix a 10mm pearl bead on each side. (as shown in the picture)

2nd, Make a similar bead pattern on each side, and then fix a 10mm pearl bead on each side again. (as shown in the picture)

3rd, Make two more shorter bead patterns, and finally use 8mm pearl beads to cover the remainder of the hair band. (as shown in the picture)

See, a beautiful pearl wedding hair crown has been finished. You can consider trying it if you are going to marry and it is also a meaningful present for your friend to match her wedding dress. Take an action as soon as possible.