Materials and tools needed:

Findings

Gemstone Cabochons

Tools

Copper Jewelry Wire  20 Gauge, 0.8mm

Copper Jewelry Wire , 0.3mm

Instructions on how to make the wire wrapping pendant:

Step 1:

1^st We cut three lines with a thickness of 0.8mm and lay them flat. Then we take a 0.3mm wire and wind it three times on the 0.8mm wire, and then in the fourth round, we wind it together with the second 0.4mm wire for one turn, and then we wind the three together. Then repeat the above steps, wrap the first thread, wrap the first two threads, and wrap the first, second, and third threads. (as shown in the picture)

2^nd When we have completed a certain length, we can press it out into a 45° angle shape and put a gemstone on it. Then press the shape in the picture to fix it. After finalizing the shape, we proceeded to wrap around both sides with 0.3mm wire.  (as shown in the picture)

Step 2:

1^st We follow the steps just now and wrap all the threads together at the bottom. (as shown in the picture) 

2^nd we put in the gemstone and take out a thread to shape the bottom of the gemstone. Take another thread and shape it on the surface of the gemstone. After doing these, we pull out a thread at the bottom, put in pearls as an embellishment, and then fix it according to your favorite shape and add an appropriate amount of decoration. (as shown in the picture) 

Isn't it interesting? Come and give it a try! You can use the same method to make other beautiful pendant!

Can't wait to share other jewelry making tutorials with you. See you next time！