How to make a baseball bracelet

The old and unused baseballs are always forgotten by your family members, and they became the junk stuff, discarded in the dark corners of your underground garage; if you didn’t scrounge something in those corners, you would never remember them. However now you get them and meanwhile find our tutorial about how to make a baseball bracelet. So DIY this bracelet, and make others marvel at your smart idea.

For how to make a baseball bracelet, the things you need are as below:

An unused baseball, knife, scissors

step 1: prepare the baseball

First, a baseball deserted for long time must be very dirty, so try to clean it as much as you can;

Second, mark the dotted lines besides seams, and then cut with knife around the seams as deep as possible;

step 2: cut out the seams for baseball bracelet

First, along with dotted marks, and cut out the seams part of baseball; (1)

Second, tug off the stuffing, leave the seam loop and trim off the excess part; (2)

Third, fold the seam loop, cutting it in half to become seam band, and then fold and cut it in half again to make two pieces of seam bands; (3)

step 3: finish the baseball bracelet

First, untie 3-5 stitches adjoining to the ends, which depends on your bracelet length; if you want the bracelet tight, you should untie more, reversely, untie less;

Second, cut off the unstitched leathers and tie knot at ends.

You have successfully finished our tutorial about how to make a baseball bracelet. Your creative work is born at this moment, congratulations! Next time, wear your baseball bracelet, watch the baseball match and cheer with your favorite team.