Materials:

8mm faceted round transparent acrylic beads *6

3mm faceted bicone transparent acrylic beads *11

Antique silver alloy bead caps *8

18mm silver color iron headpins *3

Flat round antique silver tibetan beads *6

Tibetan style toggle and tbars *1 0.

5mm silver-gray tiger tail about 35~40cm

4mm jump ring *1 2mm

spacer beads *4

Tools:

Ferronickel round nose plier

Ferronickel side cutting pliers

Wire-cutter pliers (needle cutting)

Steps: 1. Use the ferronickel side cutting pliers cut 35~40cm tiger tail, tie a circle at one end.

2. String the bicone transparent acrylic beads, flat round antique silver tibetan beads, antique silver alloy bead caps and faceted round transparent acrylic beads through the tiger tail one by one as the following.  

3. Repeat step 2 until as the following picture.  

4. Weav2 spacer beads and the tibetan style tbars, the make the end of the wire through spacer beads as the picture showing  

5. Clamp the spacer beads firmly, and then cut the superfluous wire.

6. Unlock the circle; add 2 spacer beads and tibetan style toggle together. Make the wire into spacer beads again. Then repeat step 5

7. Beads through iron headpins as showing

8. Use wire-cutter pliers (needle cutting) to open the jump ring, make a circle by ferronickel round nose plier at the end of the headpin

9. Hang the three with tibetan style toggle, clock the jump ring.

10. That’s all, finished!

  Attached List: