Nbeads Tutorials on How to Make Multi-strand Silver Necklace

Materials and tools needed:

Findings

Iron Twisted Chains, Silver Color Plated, 8x6x1mm

Iron Cable Chains, Silver Color Plated, 3x2x0.6mm

Iron Round Spacer Beads, Silver Color Plated, 5mm

12/0 Grade A Round Seed Beads, Silver Plated, 2x1.5mm

Silver Color Plated Alloy Lobster Claw Clasps, 6x12mm

Iron Open Jump Rings, Platinum, 21 Gauge

Transparent Fishing Thread Nylon Wire, Clear, 0.2mm

Tools

Iron Sewing Needles

Stainless Steel Scissors

Needle Nose Pliers

Round Nose Pliers

Side Cutting Pliers

Instructions on how to make the necklace:

Step 1:

1st, Cut a 36cm piece of silver twist chain and a 39cm piece of silver cable chain. Then use a silver jump ring to hold them together. (as shown in the picture)

2nd, Thread the silver cable chain through each loop of the twist chain in turn. Finally, use a silver jump ring to hold them together again. (as shown in the picture)

Step 2:

1st, Cut a long piece of fishing wire, slide 5 silver seed beads onto the wire, then secure them into a loop. (as shown in the picture)

2nd, Add 5 silver seed beads, 2 silver spacer beads and a 38mm piece of silver cable chain to the wire.

3rd, Repeat the previous step to continue adding silver seed beads, silver spacer beads and 38mm silver cable chain to the wire.

4th, Finally make a knot with the wire after sliding 5 silver seed beads, then cut off the extra wire.

5th, Attach a silver jump ring on each end.

Step 3:

1st, Cut a 44cm piece of silver cable chain and attach a silver jump ring on each end.

2nd, Secure the three strands of chain together with two silver jump rings, and finally attach a silver lobster clasp.

Look, do you think you can finish this gorgeous necklace? There is no professional technique in this DIY project. Give it a try if you like it! You can find all the materials you need at Nbeads.