Materials and tools needed:

Findings

Imitated Pearl Acrylic Beads, Round, White, 3mm

White Glass Pearl Round Loose Beads, 6mm

White Glass Pearl Round Loose Beads, 8mm

Iron Open Jump Rings, Platinum, 21 Gauge, 5x0.7mm

Silver Color Plated Brass Lobster Claw Clasps, 12x7x3mm

304 Stainless Steel Chain Extender, Silver

Transparent Fishing Thread Nylon Wire, Clear, 0.2mm

Tools

Iron Sewing Needles

Stainless Steel Scissors

Needle Nose Pliers

Round Nose Pliers

Instructions on how to make the necklace:

Step 1:

1st, Cut a long piece of fishing wire and string it to a needle. Add four 3mm pearl beads and two 6mm pearl beads to the wire, make a knot with the wire and cut off one end of it. (as shown in the picture)

2nd, Run the needle through four 3mm pearl beads and one 6mm pearl beads, then through one 6mm pearl beads of the ring next to the wire. (as shown in the picture)

3rd, Repeat the same steps until a necklace of the right length is created. (as shown in the picture)

Step 2:

1st, Add seven 3mm pearl beads at the end of the necklace in the same way. Then thread the wire through the second 6mm pearl beads. (as shown in the picture)

2nd, Slide 14 3mm pearl beads and one 8mm pearl bead onto the wire and thread the wire through the fifth 6mm pearl bead. Then thread the wire through the fourth 6mm pearl bead. (as shown in the picture)

3rd, Repeat the same steps, stopping at the penultimate 6mm pearl bead. (as shown in the picture)

4th, Again add seven 3mm pearl beads at the end and cut off the excess wire.

Step 3:

Attach a lobster clasp with a jump ring on one end of the necklace and an extension chain with a jump ring on the other end. So the necklace has been finished.

What a delicate pearl necklace! This necklace could be a great wedding gift for your bride-to-be friend, and you can also wear it to match your party dresses. So, if you like it, don’t hesitate, just take your time and try to make one!