Materials and tools needed:

Findings

White Glass Pearl Beads, 6mm

MIYUKI Round Rocailles Beads, (RR420) White Pearl Ceylon, 11/0

Brass Spacer Beads, Round, Golden, 4x3.5mm

Brass Micro Pave Cubic Zirconia Charms, Teardrop, Golden, 11x7.5x4mm

Ion Plating(IP) 304 Stainless Steel Lobster Claw Clasps, Golden, 9x6x3mm

Iron Open Jump Rings, Nickel Free, Golden, 21 Gauge

Transparent Fishing Thread Nylon Wire, Clear, 0.2mm

Tools

Iron Sewing Needles

Stainless Steel Scissors

Needle Nose Pliers

Round Nose Pliers

Side Cutting Pliers

Instructions on how to make the necklace:

Step 1:

1st, Cut a long piece of fishing wire and slide 5 white seed beads onto the wire, then make a knot with the wire. (as shown in the picture)

2nd, Add a gold spacer bead and 12 white seed beads to the wire.

3rd, Continue to add gold spacer beads, glass pearl beads and white seed beads to the wire till it is long enough for your neck. (as shown in the picture)

4th, Finally make a knot with the wire after sliding 5 white seed beads, then cut off the extra wire.

Step 2:

1st, Slide 15 white seed beads onto the wire, then thread the wire through the next gold spacer bead. (as shown in the picture)

2nd, Add same beads onto the wire, then thread the wire in the same ways.

Step 3:

1st, Add two jump rings and a lobster claw clasp to the end of the necklace.

2nd, Finally, attach six cubic zirconia charms to the necklace with six jump rings.

What an exquisite necklace! The materials needed for this necklace are easy to gain. Besides, the making process is not very difficult. So, if you like it, don’t hesitate, just take your time and try to make one!