Bead Tips

The bead tips are usually used assemble with the seed beads at the end of the bracelets. The perfect ending steps can be one of the most important steps in the DIY processes. Thus, learn to use the bead tips correctly is really necessary for primary learner. So, I have collected the following tips for your reference:

1. At first, string the seed bead and bead tip with wire as the picture show. Then you can start your design.

2. After beading all beads, add another bead tip and seed bead at the end. Adjust the wire of moderate compactness, neither too loose nor too tight, and then tie a knot. After finish all the steps, close both bead tips with the Jewelry Flat Nose Plier.

3. Attach the ring and Springring Clasps at each bead tip then close them.

The most important step is making sure the knot is firmly. You can use some AB glue as assistant material.

Thick nylon wire

While using the little thick nylon wire with the Beading Needles, the most common problem is most of us find that it is really hard to pass the wire through the needle eye. Then, you can just find the solution here.

1. Clip flat the top of the nylon wire with flat nose plier, about 2cm is enough.

2. Pass the flat part through the needle eye.

3. Use the plier clamp the flat part and pull gradually about 1~2cm is enough.