Are you annoying about the crystal bracelets patterns you have made previously; and do you want to try some new designs? I bet you are wondering how to make a crystal bracelet in a new way. So why not try to make an Indian head penny bracelet which also uses crystals.

The components that you need are Indian Head Pennies, 6mm bicone crystal beads(if no crystal beads, use glass beads to replace, as long as they can resemble the crystal effects), 20&22 gauge copper wire, and toggle clasp.

Then how to make a crystal bracelet, you will be tutored as follows:

How to make a crystal bracelet Step 1: prepare pennies

Drill 4 tiny holes in the pennies and remove the excess edges to make the holes smooth. And then cap the pennies.

How to make a crystal bracelet Step 2: make clove leaves

Put two strands of 22 gauged copper wires twisted together and use round nose pliers to make loops, and then the clove leaves are well prepared. Notice here, in order to make your clove leaves in good shapes, you can use hammer to flatten them

How to make a crystal bracelet Step 3: prepare jump rings

Put needles at both sides and meanwhile coil size 20 wires around them to make oval jump rings.

How to make a crystal bracelet Step 4: finish the beading

Make a crystal bicone, double clove leaves, jump ring and penny as a group, and thread the group to the 22 gauged wires till the bracelet reaches the length you want. Do not forget to leave some space for the toggle clasp.

Now you finish “how to make a crystal bracelet” project. This bracelet is a special one, because each one is involved genuine coins.